|
|
|
Address
|
Lorin Kazaz
Institute of Engineering and Computational Mechanics
University of Stuttgart
Pfaffenwaldring 9
70569 Stuttgart, Germany
|
Office
|
Pfaffenwaldring 9, 3rd Floor
Room 3.107
|
Phone
Fax
|
+49 711 685-66580
+49 711 685-66400
|
Email
|
lorin.kazaz@itm.uni-stuttgart.de
|
Field of Research
Contact Calculation in Gearing
Publications
black: published,
green: accepted for publication,
orange: submitted for publication
-
Pfister, C.; Pfister J.; Kazaz, L. and Eberhard, P.:
Stress Calculation in Worm Gears using Elastic Multibody Models. Proceedings of the 5th Joint International Conference on Multibody System Dynamics, Lisbon, Portugal, 24-28 June 2018
-
Kazaz, L.:
Investigation of Lubricant-Induced Efficiency Loss in Gear Drives by FSI via Co-Simulation between GTM and Pasimodo (in German), Thesis MSC-247, Simtech No. 16. Institute of Engineering and Computational Mechanics, University of Stuttgart, 2016. (Eberhard, P.; Ziegler, P.; Beck, F.; Schurr, D.)
-
Kazaz, L.:
Derivation of Terms for Reduction of Static Error using Feedthrough in the Floating Frame of Reference Formulation, Student Research Project STUD-443. Institute of Engineering and Computational Mechanics, University of Stuttgart, 2016. (Eberhard, P.; Ziegler, P.; Baumann, M.; Holzwarth, P.; Walz N-P.)
Teaching
-
Assistance for Biomechanics lecture (WT 2018/19)
-
Assistance for seminar in Applied Mechanics IV (ST 2018)
-
Assistance for Applied Mechanics III (WT 2017/18)
-
Seminar in Applied Mechanics II (ST 2017)
Talks
-
July 30, 2018: International Conference on Vibro-Impact-Systems, Kassel; "Gear Drive Simulations with Higher Order Ansatz Functions using Elastic Multibody Models"
-
May 28, 2018: ITM Statusseminar, Bad Herrenalb; "Gear Drive Simulations with Higher Order Ansatz Functions using Elastic Multibody Models"
-
July 7, 2017: International Conference on Computational Contact Mechanics, Lecce; "Modelling Fluid-Solid Contact using Elastic Multibody Systems and Meshfree Fluid Descriptions"
-
May 22, 2017: ITM Status Seminar, Monbachtal; "Dynamische, Elastische Getriebesimulationen"
Supervised Student Projects und Theses
-
Untersuchung zur Anwendbarkeit von nicht strukturerhaltender Modellreduktion bei der Simulation von Zahnradkontakten (in German), Master Thesis MSC-260.
Institute of Engineering and Computational Mechanics, University of Stuttgart, 2018.
Supervision together with Dr.-Ing. Pascal Ziegler
-
Weiterentwicklung der Kontaktberechnung in GTM für Schneckenräder mit Spannungsberechnung, Student Project STUD-476.
Institute of Engineering and Computational Mechanics, University of Stuttgart, 2017.
Supervision together with Christian Pfister, M. Sc.
-
Untersuchung des Einflusses verschiedener Kontakte und Kontaktmodule anhand eines industriellen Planetengetriebes mit GTM und Simpack, Student Project STUD-468.
Institute of Engineering and Computational Mechanics, University of Stuttgart, 2017.
Supervision together with Dipl.-Ing. Dennis Schurr.
Additional Services at the Institute
|
|